1x pneumatic angle seat valve model DN10-DN65 for pulsating vacuum sterilizer
1PC pneumatic angle seat valve model DN10-DN65 for pulsating vacuum sterilizer. Wiring instructions for circuit board and shock head (ceramic plate transducer). Shock head two wiring, two ceramic pieces of the middle of the wiring piece for the positive pole, by the upper and lower metal column for the negative pole, remember not to connect the reverse. The silver-coated side of the ceramic plate of the transducer is a negative electrode, while the larger side of the other two silver layers is a positive electrode, and the smaller side is a negative plate. The silver layer on the ceramic plate is not resistant to high temperature. When welding the power line, the temperature of the soldering iron shall not exceed 280 degrees. It is better to use the constant temperature soldering iron and set the soldering iron temperature as 250 degrees. The larger side of the shock head (with a screw hole) is the shock surface that can be glued to the bottom of the cleaning basin.
The cleaning basin should be grounded reliably. Shock head or transducer ceramic plate application shock head glue firm paste on the bottom of the cleaning basin, can also be used AB adhesive paste, but the effect is slightly poor, such as using epoxy resin ratio of 10:4 can be. This item is in the category "Business & Industrial\Electrical Equipment & Supplies\Other Electrical Equipment & Supplies".
The seller is "2012htj*2012htj" and is located in this country: CN. This item can be shipped worldwide.
- Brand: Unbranded
- MPN: DN10-DN65
- Type: Ceramic heat sink